*******************************************************************************************************************
Diff being fitted, 7 1/2" viscous LSD 3.64.Diff top bolts not yet fitted, 7" diff uses a stud and a 12mm spacer. Drivers side drive shaft and lobro fitted.11 March 2005
************************************************************************************************************
Drive shaft stub axle flange.Also you can see the wires for speedo sensor08 March 2005
sierra calliper and disc fitted Right and left westfield alloy uprights.
****************************************************************************************************************
Build up of front suspension , steering and brakes.06 March 2005
Clutch cable, brake master cylinder and front brake pipes fitted.
**********************************************************************************************************************
Trial fit of tub to chassis.
02 March 2005
Fitting detachable arches to body prior to fitting tub onto chassis.
***************************************************************************************************************
Left hand aluminium outer side panel fitted.Steering column being fitted , note on lower column mounting there needs to be a 12mm spacer fitted. This is required for the SVA so that there is a angle between the lower column and upper column.21 February 2005
Chassis upside down and floor panels being fitted.
Floor mounted pedals (must remember to tighten them nuts).
18 February 2005
Front bulkhead and tunnel panels being fitted.
First panel being fitted.
17 February 2005
My Westfield on day of collection safely in my garage awaiting build.
11 February 2005
